- August 28, 2021
- By electricaldiagnosticsurveys
Article 110.2 of NFPA 70E 2018 specifies the safety training requirements when working on equipment that presents an electrical hazard. The introduction to this section provides a summary of the arc flash training requirements: “Such employees shall be trained to understand the specific hazards associated with electrical energy. They shall be trained in safety-related work practices and procedural requirements, as necessary to provide protection from the electrical hazard associated with their respective job or task assignment. Employees shall be trained to identify and understand the relationship between electrical hazards and possible injury.”
The article then provides specifics on what is required, including specifying the requirements for qualified person and unqualified person training.
Some facility managers already comply with the requirement that employers meet with contractors to communicate known hazards and information about the facility installation that the contractor needs to make assessments. However, Article 110.1(C) requires this meeting to be documented.
The 70E standard also adds emphasis to its provision that employees who work around (not just on) energized electrical equipment must be safety trained. Article 110.2(D)(1)(f) requires employers to perform annual inspections (audit) to ensure each employee is complying with all safety-related work practices outlined in 70E. And Article 110.2(D)(3) requires that employees be retrained at intervals not to exceed 3 years, while 110.2(E) states that the training content must be documented. As far as OSHA is concerned, if not documented, compliance wasn’t achieved. What’s more, facility owners must now audit their safety training program and field work at least every 3 years to ensure it complies with 70E [110.3(H)(1) and (2)]. The audit also must be documented and revisions made to the safety program if any elements are not in compliance [110.3(H)(3)]. Also, any changes as a result of a new cycle of the 70E need to be updated. These changes supersede any previous additions.
Regarding use of equipment, Article 110.4 now specifies that only qualified persons perform testing and maintenance within the limited approach boundary. According to OSHA 1910, the definition of qualified includes required training, demonstrated skills, and knowledge of installation and hazards. The standard also now includes use of GFCIs where required by local, state and federal codes or standards.
Requirements For The Training Of Unqualified Persons
Article 110.2(D)(2) Unqualified Persons. Unqualified persons shall be trained in, and be familiar with, any electrical safety-related practices necessary for their safety.
Article 110.2(D)(3) Retraining. An employee shall receive additional training (or retraining) under any of the following conditions:
1. If the supervisor or annual inspections indicate that the employee is not complying with the safety-related work practices.
2. If new technology, new types of equipment, or changes in procedures necessitate the use of safety-related work practices.
3. If he or she must employ safety-related work practices that are not normally used during his or her regular job duties.
OSHA 1910.332(b)(2) requires unqualified workers to be trained in the electrical safe work practices that are necessary for their safety. Unqualified workers, such as painters or cleaners, occasionally come into contact with energized equipment, and therefore they must be trained to recognize and avoid electrical hazards. Equipment operators often open the doors to electrical equipment to change a fuse or reset a contactor thus exposing themselves to energized conductors and circuit parts. Training would be required for personnel performing these job tasks. Painters often remove lighting fixtures, coverplates, work in damp locations and work in close proximity to overhead service conductors. The benchmark for training is anyone exposing themselves to voltages higher than 50 volts are at risk. Above 50V, if grounded, is enough to cause electrocution.
EDS specializes in many different aspects of electrical training and engineering.
All training courses are available in affordable prices.
To get a free no obligation quote, please email us your details or call us and we will get back to you the same day.